By venting these gasses along with oil mist/vapor from the crankcase and route it back into the intake manifold so it can be burned off. This is a poor fix from automobile manufacturers because over time the excess oil vapor collects along the inside of the intake tract and forms a sludge.
This leads to a variety of issues including carbon build up, retarded timing, detonation, power loss and even engine failure. UPR s fix for the PCV system used on many engines for reducing toxic gasses from being released into the atmosphere and eliminating positive crankcase pressure / Blow-By.
What does a UPR Catch Can do? UPR s Billet Catch Can / oil-air separator will condense and collect the oil vapor before it has any chance to reach the intake tract.As the gas and oil vapor enters UPR s can they pass through a Chambered filtering system that cools the oil vapor and gives it something to adhere. Then the oil forms into droplets and collects in the bottom of the UPR Catch Can so that they can later be drained. This is where the additional Chambered filtering system comes into play allowing only the clean air to pass through so it can eliminate unwanted blow-by. All engines have blow by otherwise there would be no need for a PCV system on your engine.
PCV = Positive Crankcase Valve, which eliminates Positive Crankcase Pressure. UPR s Catch Can have become one of the most widely used and recommended cures for just about every application. The engine size and horsepower level is not relevant to the performance of the UPR Catch Can.UPR s Catch Can have become a cornerstone by improving the Performance and Economy on any vehicle you install it on. Step 1 - Remove the factory or aftermarket air intake tube. (Removing 2 hose clamps and 1 sensor plug). Step 2 - Remove the factory engine cover by lifting the front and pulling towards you. (Hose Cut-Out n Rear Alignment Pins on Intake Cover). Step 3 - Remove the PCV Hose from the Throttle Body and Top of Intake Manifold. (Remove the 2 rubber ends on each side for a much cleaner install than the 2 Adapter Barbed Fittings). Step 4 - Install the the UPR Dodge Ram Catch Can in the Hole in the Front of the Cylinder Head. (The Mounting Hole is just at the Lower Left of the Freeze Out Plug in the Passenger Cylinder Head). Step 5 - Now you can Install the 1/2 Hoses on each side of the UPR Dodge Ram Catch Can. (Only the UPR Catch Can has a 1/2 Straight Barb Fitting for a Straight Shot to the Intake Manifold). Step 6 - Re-install your Air Intake Hose and Factory Engine Cover to Finish. (Now Double Check all your Work). The item "09-19 Dodge RAM Black Billet Catch Can All HEMI Engine Technology 1500 2500 3500" is in sale since Friday, April 12, 2013.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Filters\Oil Filters". The seller is "uprproducts" and is located in Lake Worth, Florida. This item can be shipped worldwide.